Getting the absolute best performance, lowest friction, and maximum mileage out of your Squirt Performance Hot Wax comes down to one crucial step: Deep-cleaning your chain before every hot-wax treatment—whether it’s your first time applying Hot Wax or doing a reset.
For a first-time application on a new chain, complete removal of factory grease is essential for the wax to adhere properly. For a reset on a used chain, deep-cleaning prevents transferring accumulated road grit into your clean Hot Wax solution. Keeping your chain completely clean before waxing preserves the high-performance quality of your wax, allowing you to enjoy maximum chain life and mileage between treatments.

To ensure 100% efficiency, follow our step-by-step deep-cleaning and application guidelines below.
The Key Step: Deep-Cleaning Before Waxing and Re-Waxing
- Boil & Clean: Remove the chain from the bike and submerge it in approximately 400–500 ml of boiling water with one 30 ml sachet of Squirt Biodegradable Bike Cleaner Super Concentrate. Agitate the chain for 5–10 minutes while the water is boiling. The boiling water helps melt and remove factory grease or old wax, while the cleaner lifts and encapsulates remaining dirt and contamination from the chain. If the water is found to be very dirty, repeat this step.
- Rinse & Dry: Rinse the chain thoroughly with clean water, then dry it as much as possible using compressed air or a clean microfibre cloth.
- IPA Flush: Follow this with a quick 60-second rinse in isopropyl alcohol (IPA). A simple method is to place the chain in a wide-mouthed drinking bottle or glass jar with a lid, add enough IPA to cover the chain, shake the container vigorously, then remove the chain and allow it to dry completely.

Standard Application Steps
- Once your chain is completely clean, degreased, and dry, proceed with the melting process:
- Thread the clean chain onto a swishing wire for easy handling.
- Pour your wax into a suitable melting pot or slow cooker.
- Add the chain to the pot and heat until the wax reaches 93–95°C (200–203°F). Do not exceed 100°C.
- Turn off the pot and gently agitate the chain in the molten wax for 3–5 minutes so the chain and wax equalize in temperature for full internal penetration.
- Remove the chain, hang it to cool for ~20 minutes, and manually flex the links before installation.

Quick Tips for Best Results
- Top-Ups Between Resets: You don’t need to hot-wax after every ride! Use Squirt Drip Wax as a top-up when the chain starts to sound dry. You can typically use 3–4 drip-wax top-ups before doing a full hot-wax reset.
- Protect Your Wax Pot: Only use enough wax to submerge the chain (1/3 to 1/2 a bag at a time). This preserves the rest of your 500g pack and keeps your working wax bath cleaner for longer.
Updated FAQ: Have questions about heating temperatures, on-bike cleaning, or top-up intervals? Visit our updated Frequently Asked Questions page for full details!








